Land Pride 380-344A, Installation Instructions Manual

Page: 5 / 12

Assembly Instructions
7/1/20 Third Function Valve Kit #380-344A & #380-348A Installation Instructions Manual No. 380-347M
5
Control Lever Assembly Without Cab
Figure 10
Control Lever Assembly
Refer to Figure 10 if tractor is without cab:
Refer to Figures 11 & 12 if tractor is with cab:
1. Remove existing knob from control lever (A).
2. Install new control handle (#1) onto control lever (A).
Adjust control handle to align the push buttons to suit
the operator and then tighten set screws (#1A).
Tighten jam nuts (#1B) to lock set screws.
3. Refer to Figure 10: Without a cab, run wire harness
(#1C & #1D) along side control lever (A) and through
floor opening (B) as shown.
4.
Refer to Figure 11:
With a cab, remove rubber
boot (D) from flange (C) and run wire harness
(#1C & #1D) through the boot and out the bottom of
shield (E).
5.
Refer to Figure 12:
With a cab, run wire harness
(#1C & #1D) through floor opening (F).
6.
Refer to Figure 11:
Replace boot (D) over flange (C).
7. Attach wiring harness (#1C & #1D) to control
lever (A) as needed with zip ties (#26).
Push Buttons
1
1A 1B
A
B
1C
1D
Attaches to the Solenoids
26
26
26
74478
Attaches to the Battery
Control Lever Assembly With Cab
Figure 11
Control Lever Assembly With Cab
Figure 12
1C
1
A
D
Push Buttons
1D
Attaches to
the Solenoids
Attaches to
the Battery
E
1A 1B
26
C
74480
1C 1D
E
F
74481