Land Pride 380-344A, Installation Instructions Manual

Page: 4 / 12

Assembly Instructions
4
Third Function Valve Kit #380-344A & #380-348A Installation Instructions Manual No. 380-347M 7/1/20
Connect to Power Beyond Port
Refer to Figure 1 on page 2:
1. Refer to Figure 7: Locate and remove steel tube (L).
It is connected to the power beyond port and return to
tank port. Discard or store removed hardware (J & K)
and steel tube (L).
2. Refer to Figure 1 on page 2: Verify banjo hose (#7)
is attached to port (T) on valve (#5).
Refer to Figure 8:
3. Run banjo hose from the valve along the left side of
the tractor toward the rear wheel.
4. Run banjo hose (#7) up behind all existing tubes,
linkages, brackets, etc.
Refer to Figure 9:
5. Cross banjo hose (#7) over to the right side of the
tractor as shown and connect banjo fitting to the tank
port with banjo bolt (#7A) and banjo washers (#7B).
Make sure one washer is below and one washer is
above the banjo fitting.
6. Verify banjo hose (#7) is not over the raised shoulder
and then tighten banjo bolt (#7A).
7. Refer to Figure 1 on page 2: Verify hose (#2) is
attached to port (P) on valve (#5).
Refer to Figure 8:
8. Run hydraulic hose (#2) from the valve along the left
side of the tractor toward the left rear wheel.
9. Run hydraulic hose (#2) up behind all existing tubes,
linkages, brackets, etc.
Refer to Figure 9:
10. Cross hydraulic hose (#2) over to the right side of the
tractor and down to the power beyond port.
11. Attach straight adapter (#21) to the power beyond
port and tighten.
IMPORTANT:
Land Pride recommends that your
dealer connect hydraulic hoses (#2 & #7) to your
tractor’s power beyond port and return to tank port.
Improper hook-up can cause damage to your tractor
and/or your third function valve.
NOTE: Illustrations are with tractor cab and wheels
removed to illustrate the components and their
location. It is not necessary to remove the cab, seat,
or wheels to connect to the power beyond ports or
route the wiring harness.
IMPORTANT:
Because the return to tank port has a
raised shoulder, the banjo hose must crossover the
transfer case in front of the front seat mount and
align with the tank port around the 1 o'clock position
as shown. Clock positions between 9 and 12:30 will
cause the raised shoulder on the tank port to
interfere with the hose and will result in an oil leak.
12. Attach elbow end of hydraulic hose (#2) to straight
adapter (#21) and tighten.
13.
Refer to Figure 1 on page 2:
Tighten hoses (#2 & #7)
to elbows (#3A & #3B) and elbows to valve (#5).
14.
Refer to Figure 8:
Secure hoses (#2 & #7) to the left
side of the tractor with zip ties (#26) as needed.
Remove Power Beyond Steel Tube
Figure 7
Route Hydraulic Houses Along the Left Side of Tractor
Figure 8
Connect Hydraulic Hoses to the Tractor Ports
Figure 9
L
J
K
Power Beyond Port
74457
Return to Tank Port
7
2
Filter
74458
7
Tube
Bracket
Rods
Linkage
2
26
Tube
7
21
2
Power Beyond Port
7B
7A
74459
Front Seat Mount
Raised Shoulder
Return to Tank Port