Land Pride 380-166A, Installation Instructions Manual, Page: 3 / 12

Assembly Instructions
1/20/21 Third Function Valve Kit #380-166A & #380-334A Installation Instructions Manual No. 380-167M
3
Loader Valve
Figure 3
Outlet Block (#42) located under tractor platform
Figure 4
Connect to Power Beyond Port
Refer to Figure 3 & Figure 4:
1. Locate and remove green line hydraulic hose (#41)
that connects power beyond port “P1” to elbow (#44)
located on loader valve (#43).
Refer to Figure 1 on page 2:
2. Connect hydraulic hose (#16) from “P” port to port
“P1” in outlet block (#42). Tighten the hose to the
port.
3. Connect hydraulic hose (#14) from “T” port to elbow
(#44). Tighten hose to the elbow.
4. Secure hoses (#14 & #16) to the tractor as needed
with cable ties (#3).
41
43
44
74883
41
42
74884
P1
IMPORTANT: Land Pride recommends that your
dealer connect hydraulic hoses (#14 & #16) to your
tractor’s power beyond port and loader valve port.
Improper hook-up could cause damage to your
tractor.
IMPORTANT:
DO NOT connect hydraulic hoses
(#14 & #16) to the loader valve and power beyond
port if the outer block feeds equipment mounted on
the back of the tractor such as a backhoe. The
instructions below do not apply in this situation.
Have your nearest dealer hook-up these hoses.
Improper hook-up can damage your tractor.
5. Check tractor hydraulic fluid level. If low, add
recommended hydraulic fluid. Refer to your tractor
Operator's Manual for recommended hydraulic fluid
and procedure for checking hydraulic fluid level.
Control Lever Assembly
Figure 5
Control Lever Assembly
Refer to Figure 1 on page 2 & Figure 5:
1. Remove existing knob (not shown) from end of
control lever “C”.
2. Install new control handle (#12) over end of control
lever “C” with push buttons facing operator as
shown.
3. Tighten set screws (#4) against control lever “C”.
Tighten jam nuts (#7) to secure set screws (#4).
Refer to Figure 1 on page 2:
4. Reference Wire Connections “A”: Connect one
black wire in harness (#40) to one black wire in
harness (#39) and the other black wire in
harness (#40) to one white wire in harness (#39).
5. Reference Wire Connection “B”: Connect the two
red wires in harness (#40) to one end of wire (#38)
with fuse holder (#13), and the opposite end of
wire (#38) to the positive (+) post on the battery.
Refer to Figure 5:
6. Secure wiring with cable ties (#3) as needed.
Push buttons
40 4
12
C
3
7
37119