Assembly Instructions
BX Third Function Valve Kit 380-137A Assembly Instructions Manual No. 380-145M
5/3/19
2
BX Third Function Valve kit
Figure 2
Right-Hand Side
Left-Hand Side
35833
T-Port
P-Port
Connect Hydraulic Hoses to Power Beyond
Refer to Figure 1 & Figure 2:
1.
Place chocks in front and back of tractor’s left rear
wheel.
2.
Loosen lug nuts on right rear wheel. Do not remove
lug nuts at this time.
3.
Jack right rear wheel off the ground and place a jack
stand under the right rear wheel axle.
4.
Lower right rear axle onto the jack stand. The wheel
should still be slightly off the ground. Make sure jack
stand is secure and will not slip out from under tractor
axle.
5.
Remove lug nuts and right rear wheel.
6.
Locate steel line connecting power beyond port of
the loader valve to the outlet block. The outlet block is
directly behind the right rear tire. The steel line is two
shorter lines connected together to make one long
steel line. Remove the rear short line.
7.
Connect free end of hydraulic hose (#17) to power
beyond port on the outlet block.
IMPORTANT:
Land Pride recommends that your
dealer connects hydraulic hoses (#13 & #17) to your
tractor’s power beyond ports. Improper hook-up
could cause damage to your tractor or valve.
8.
Connect free end of hydraulic hose (#13) to the
remaining front short steel line, which is connected to
the loader valve.
9.
Secure hoses to underside of tractor with cable
ties (#4).
10. Replace right rear wheel and screw lug nuts on until
snug.
11. Jack axle up and remove jack stand.
12. Lower tractor down and tighten lug nuts in a
crisscross pattern. Refer to tractor Operator’s Manual
for proper torque value.
13. Remove chocks.
14. Check tractor hydraulic fluid level. If low, add
recommended hydraulic fluid. Refer to your tractor
Operator’s Manual for recommended hydraulic fluid
and procedure for checking hydraulic fluid level.
Control Lever Assembly
Refer to Figure 3 on page 3:
1.
Remove existing knob from end of control lever “B”.
2.
Install new joystick (#14) over end of control
lever “B” with push buttons “C” facing operator.
3.
Tighten set screws (#5) against control lever “B”.
Tighten jam nuts (#7) to secure set screws.
