![background image](http://html1.mh-extra.com/html/land-pride/33436/33436_operators-manual_673057016.webp)
Section 2: Operating Instructions
2/15/18
12
•
Do not use implement to lift objects; to pull objects such as
fence posts, stumps, etc; or to push objects. The unit is not
designed or guarded for these uses.
•
Do not use implement to tow other equipment unless it is
designed with a tow hitch. Doing so can result in loss of
control and damage the equipment.
Transporting
CAUTION
!
To avoid minor or moderate injury:
When traveling on public roads whether at night or during the
day, use accessory lights and devices for adequate warning to
operators of other vehicles. Comply with all federal, state, and
local laws.
1.
When raising the ditcher to transport, be sure that the
driveline does not contact tractor or implement and
the parking stand is pined in the fully up position.
2.
Be sure to reduce tractor ground speed when turning.
Leave enough clearance so that the ditcher does not
contact obstacles such as buildings, trees, or fences.
3.
Select a safe ground travel speed when transporting
from one area to another. When traveling on
roadways, transport in such a way that faster moving
vehicles may pass you safely.
4.
When traveling over rough or hilly terrain, shift tractor
to a lower gear.
IMPORTANT:
Do not use ditcher as a grinder of
wood stumps, concrete, etc. Doing so may severely
damaged as the unit as it is not designed for this
application.
IMPORTANT:
Always disengage PTO before raising
ditcher to transport position.
Operating Instructions
1.
Operate with 540 rpm PTO tractor.
2.
Engage
PTO at approximately 200 RPM and slowly
increase to 540 PTO RPM.
3.
Ditching should not be done in wet conditions as soil
will stick to the blades and reduce the digging ability
of the ditcher.
4.
DO NOT
make sharp turns or attempt to back up
while ditcher is in the ground.
5.
DO NOT
engage PTO with machine in the fully raised
position.
6.
DO NOT
drop 3 point hitch. Lower the Powered
Ditcher slowly to the ground.
7.
Ground speed should be between 3 and 5 mph for
normal conditions. Under extreme rocky conditions
ground speed may have to be reduced for
satisfactory performance. In general, the slower the
ground speed the better job.
8.
Proper operating depth and ground speed are
interrelated and performance of the Powered Ditcher
will improve with operator experience.
9.
Periodically check for foreign objects wrapped
around the blades and remove them after
disengaging PTO, turning off tractor, remove ignition
key, and wait for blades to come to a complete stop
before dismounting from tractor.