LANCOM L
-
300 Access Point series
Chapter 2: Installation
31
EN
Antennas are only to be attached or changed when the device is swit-
ched off. Mounting or demounting antennas while the device swit-
ched on may cause the destruction of the WLAN module!
When assembling separately purchased mobile radio antennas please
note that the maximum allowed transmission power of the wireless
LAN according to EIRP in the country in question may not be excee-
ded. The system operator is responsible for adhering to the threshold
values.
LAN
– You can first connect the L-300 Access Point to your LAN. Plug in
one end of the supplied network cable (green connectors) to the LAN con-
nector on the device
and the other end into an available network con-
nector socket in your local network or on a hub or switch. Alternatively
you can connect a single PC.
The LAN connector automatically recognizes the wiring (Auto MDI/X) and
the transfer rate (10/100/1000 Mbit with LANCOM L-305agn Wirelesss
and LANCOM L-310agn Wirelesss, 10/100 Mbit with LANCOM L-315agn
dual Wireless) by autosensing.
Information about the installation of PoE can be found in the information
box
→
'Power over Ethernet—elegant power supply over LAN cabling'.
DSLoL
– if you wish to operate the access point in DSLoL mode you can
either connect the device directly to the DSL modem (exclusive mode) or
via a hub or switch in the wired LAN (automatic mode).
In exclusive mode, plug one end of the network cable supplied (green
connectors) into the LAN port of device
and plug the other end into
the corresponding port on the DSL modem.
In automatic mode, plug one end of the supplied network cable
(green connectors) to the LAN port on device
and the other end
into an available network connector socket in your local network (or
a free socket on a switch or hub).
Power supply
– socket
is for connecting the power supply unit pro-
vided.
Alternatively you can use the PoE facility for the power supply (please refer
to
→
'Power over Ethernet—elegant power supply over LAN cabling').
