LANCOM L
-
300 Access Point Serie
Chapter 2: Installation
31
EN
device and resets the configuration to its factory settings. All LEDs on
the device light up continuously. Once the switch is released the
device will restart with the restored factory settings.
After resetting, the device starts completely unconfigured and
all
set-
tings are lost. If possible be sure to backup the current device confi-
guration
before
resetting.
After resetting, the LANCOM Access Point returns to managed mode,
in which case the configuration cannot be directly accessed via the
WLAN interface!
Hardware installation
Installation of the L-300 Access Point devices involves the following steps:
LANCOM L-310agn
Wireless and
LANCOM L-315agn
dual Wireless only
Antennas
– screw the antennas supplied to the back of the L-300 Access
Point. Depending on how the antennas are to be used, the 'Antenna
Grouping' parameter may need to be configured in order provide the
desired MIMO behavior (
→
'Advanced Wireless LAN Configuration').
Antennas are only to be attached or changed when the device is swit-
ched off. Mounting or demounting antennas while the device swit-
ched on may cause the destruction of the WLAN module!
When assembling separately purchased mobile radio antennas please
note that the maximum allowed transmission power of the wireless
LAN according to EIRP in the country in question may not be excee-
ded. The system operator is responsible for adhering to the threshold
values.
LAN
– You can first connect the L-300 Access Point to your LAN. Plug in
one end of the supplied network cable (green connectors) to the LAN con-
nector on the device
and the other end into an available network con-
nector socket in your local network or on a hub or switch. Alternatively
you can connect a single PC.
The LAN connector automatically recognizes the wiring (Auto MDI/X) and
the transfer rate (10/100/1000 Mbit with LANCOM L-305agn Wirelesss
and LANCOM L-310agn Wirelesss, 10/100 Mbit with LANCOM L-315agn
dual Wireless) by autosensing.
Information about the installation of PoE can be found in the information
box
→
'Power over Ethernet—elegant power supply over LAN cabling'.
