LANCOM L
-
300 Access Point Serie
Chapter 2: Installation
25
EN
Top
The two top-mounted LEDs enable the main function status to be assessed
even if the device is positioned vertically.
Power
This LED provides information on the device's operating state.
The power LED blinks alternately in red/green until a configuration
password has been set. Without a configuration password, the confi-
guration data in the LANCOM are unprotected. Normally you would
set a configuration password during the basic configuration (instruc-
tions in the following chapter). Information about setting a configu-
ration password at a later time is available in the section 'The Security
Wizard'.
Power
WLAN-Link
Off
Device switched off
Green
Blinking
Self-test after power-up
Green
On (perma-
nently)
Device operational
Red/green
Blinking alterna-
tely
Device insecure: Configuration password not set
Orange/green
In the housing
cover; blinking
alternately with
the online LED
At least one WLAN module is in managed mode and
has not found a WLAN Controller yet. The correspon-
ding WLAN module(s) is/are switched off until a WLAN
Controller is found to supply a configuration, or until
being switched manually into another operating mode.
Orange /red
In the housing
cover; blinking
alternately with
the online LED
At least one WLAN module is in managed mode and
has found a WLAN Controller. However, the WLAN
Controller cannot assign a configuration because the
firmware and/or the device's loader version is not com-
patible with the WLAN Controller.
