LANCOM 7111 VPN – LANCOM 8011 VPN
Chapter 9: Troubleshooting
67
EN
9 Troubleshooting
In this chapter, you will find suggestions and assistance for a few common dif-
ficulties.
9.1
No WAN connection is established
After start-up the router automatically attempts to connect to the access pro-
vider. During this process, the Online LED will blink green. If successful, the
LED will switch over to steady green. If, however, the connection can't be
established, the Online LED will light up red. The reason for this is usually one
of the following:
Problems with the cabling?
Only the cable provided with your device should be used to connect to the
WAN. This cable must be connected to the Ethernet port of your broadband
access device. The WAN link LED must light green indicating the physical con-
nection.
Has the correct transfer protocol been selected?
The transfer protocol is set along with the basic settings. The basic setup wiz-
ard will enter the correct settings for numerous DSL providers automatically.
Only if your DSL provider is not listed, you will have to enter manually the pro-
tocol being used. In any case, the protocol that your DSL provider supplies you
with should definitely work.
You can monitor and correct the protocol settings under:
9.2
DSL data transfer is slow
The data transfer rate of an broadband (Internet) DSL connection is dependent
upon numerous factors, most of which are outside of one's own sphere of
influence. Important factors aside from the bandwidth of one's own Internet
connection are the Internet connection and current load of the desired target.
Configuration tool
Run command
LANconfig
Management
Interfaces
Interface settings
WAN Inter-
face
WEBconfig
Expert Configuration
Setup
Interfaces
WAN Interface