LANCOM 3550 Wireless
Chapter 5: Setting up the UMTS profile
48
EN
5.3.3
UMTS/HSPDA only or automatic UMTS/HSPDA/GPRS selection
UMTS/HSPDA coverage is not yet universally available. It is still possible to
establish a data connection even in areas without UMTS/HSPDA reception by
selecting the 'automatic' operating mode. With this setting, the data card in
the LANCOM will initially attempt to establish a connection via UMTS/HSPDA.
The card will automatically switch to the GPRS network if the UMTS/HSPDA
signal proves to be too weak to support data transfer of the necessary quality.
If required, the operating mode can be permanently set to either UMTS or
GPRS. The desired operating mode can be set in the UMTS/GPRS profile set-
tings which are to be found in LANconfig in the configuration area 'Interface'
on the 'WAN' tab with the
UMTS/GPRS profile
button.
Summary of Contents for 3550 Wireless
Page 1: ...LANCOM 3550 Wireless...
