Lancia Voyager 2015, Owner'S Handbook Manual

Page: 44 / 380

WARNING!
(Continued)
• A frayed or torn seat belt could
rip apart in a collision and leave
you with no protection. Inspect
the seat belt system periodically,
checking for cuts, frays, or loose
parts. Damaged parts must be re-
placed immediately. Do not disas-
semble or modify the seat belt
system. Seat belt assemblies must
be replaced after a collision.
LAP/SHOULDER BELT
OPERATING INSTRUCTIONS
1. Enter the vehicle and close the
door. Sit back and adjust the seat.
2. The seat belt latch plate is above
the back of the front seat, and next to
your arm in the rear seat (for vehicles
equipped with a rear seat). Grasp the
latch plate and pull out the seat belt.
Slide the latch plate up the webbing as
far as necessary to allow the seat belt
to go around your lap.
3. When the seat belt is long enough
to fit, insert the latch plate into the
buckle until you hear a “click.”
4. Position the lap belt so that it is
snug and lies low across your hips,
below your abdomen. To remove
slack in the lap belt portion, pull up
on the shoulder belt. To loosen the lap
belt if it is too tight, tilt the latch plate
and pull on the lap belt. A snug seat
belt reduces the risk of sliding under
the seat belt in a collision.
5. Position the shoulder belt across
the shoulder and chest with minimal,
if any slack so that it is comfortable
and not resting on your neck. The
retractor will withdraw any slack in
the shoulder belt.
Pulling Out Belt And Latch Plate
Inserting Latch Plate Into Buckle
Removing Slack From Belt
38
PAGE POSITION: 42 JOB: 1750840-en-2015_LANCIA_VOYAGER_OM_EE.530.02.350 pubnum: 530.02.350