D. Release the mode switch.
E. Hold cup under spout and depress the dispensing paddle. An initial eight (8) to ten (10) ounces
(236.6 ml to 295.7 ml) of water will be dispensed before the concentrate/water mixture reaches
the nozzle.
1.10 ADJUST WATER TO CONCENTRATE RATIO (
o
BRIX)
A. Install dispensing nozzles.
B. Inlet water is distributed through a common water system with the regulator pressure preset at
25 PSIG (1.76 kg/cm
2
). With a proper water source each spout will dispense approximately
1.2 ounces (35.5 ml) of water per second. When mixed with concentrate (4 to 1 ratio), the
finished drink will be dispensed at 1.5 ounce (43 ml) per second.
C. The unit is factory preset (electronically) for the following products and ratios.
LEFT
RIGHT
PRODUCT
RATIO
PRODUCT
RATIO
Grapefruit
4:1
Orange
4:1
NOTES:
Because the ratios are factory preset electronically, they are not exact and may
require a slight adjustment at the time of installation. This can be accomplished by
using a refractometer as follows:
1. Dispense a 5 or 6 ounce (147.9 or 177.4 ml) cup of product and discard.
2. Dispense a 5 or 6 ounce (147.9 or 177.4 ml) cup of product and stir thoroughly.
3. Using a refractometer, read the ratio (
o
Brix). Adjust as necessary (as explained
in Section 1.10.D below) and re-Brix.
D. To adjust the
o
Brix, loosen two (2) screws on face of control panel until control panel can be
pulled partially out of control housing. Screws are captive and can be used to pull control panel
from control housing. On the main control printed circuit board (PCB) are two adjusting knobs
which control the
o
Brix of the left and right sides. The control on the left side (facing the control
panel) controls the left motor and the right control is for the right motor (refer to Figure 1).
Figure 1 - Motor Speed Controls and Flush Switch.
To adjust the
o
Brix turn the adjusting control as follows:
Decrease
o
Brix (less concentrate)............................................ Counter Clockwise
Increase
o
Brix (more concentrate)....................................................... Clockwise
3
Summary of Contents for CENTURION II 85-0056
Page 28: ...11 ILLUSTRATIONS PARTS LISTINGS AND WIRING DIAGRAMS 11 1 CENTURION II FINAL ASSEMBLY 24 ...
Page 30: ...26 11 2 CENTURION II PUMP REGULATOR ASSEMBLY ...
Page 32: ...11 3 CENTURION II WATER CONCENTRATE COMPONENT ASSEMBLY 28 ...
Page 34: ...30 11 4 CENTURION II REFRIGERATION ASSEMBLY ...