Lamtec ETAMATIC OEM, Quick Reference

Page: 11 / 24

10
6 Fault
6 Fault
6.1 Reading Faults
In initial state of customer interface (not MANUAL mode) while no fault state of ETAMATIC
OEM occured the upper line is switching over.
In case of a fault a current fault code and corresponding firing-rate values are shown. In the
next stage a marquee with the pending fault is displayed (see chapter
5.3.1 Initial State
).
6.2 Recalling Fault History
The ETAMATIC OEM records the last 10 faults including the corresponding operating hours
counter
value.
In initial state (not MANUAL mode), provided that no fault message of the ETAMATIC OEM is
pending, the upper display line is switching over:
6.3 Resetting Faults
NOTICE
This may result in a RESET of the O
2
trim when a fault of O
2
trim is pending (see chapter
5.3.5
RESET
).
Contact your service provider in an event of a fault.
You may read off the display values using the SHIFT key (e.g. of operating hours, time)
in the event of a fault. All display values are frozen.
You may scroll through the fault history using the arrow keys.
See also chapter
5.3.1 Initial State
.
Press the RESET key to reset a fault of ETAMATIC OEM.