Lamtec ETAMATIC OEM, Quick Reference

Page: 10 / 24

9
5 Customer Interface
NOTICE
If the mode „Setting firing rate controller“ is active (LED manual flashes) this key has no effect.
5.3.3 Display Level 2
5.3.4 Manual
Function of the manual key
In the HAND mode, the regular firing rate input of ETAMATIC OEM can be manually adjusted.
5.3.5 RESET
If the O
2
trim is in fault condition and the lower display line shows the O
2
value, the RESET-
key also resets the O
2
trim.
In the customer interface the RESET–key effects as follows:
• Leaving the 2nd display level in the lower display line.
• Status report in the upper display line
• Disable manual-mode
• Deactivate mode „set burner firing rate controller“
• Display of operating mode (e.g. Burner OFF)
• Display of O
2
value* (if activated)
• Flame intensity
• Operating hours
Press the key for more than 5 sec., the lower display line switches to the 2
nd
level. (see
chapter 8.7 Calling the Checksums ).
Press the RESET Key to leave display level 2.
Press HAND key → LED in HAND key lights up
With these arrow keys the firing rate value can be adjusted.
Press HAND key to finish.
Faults can be reset through the RESET key.