RTH button
Confirm
Forward/Backward
Map
Way point flight
Route planning
flight
Flight altitude
Start
Set course point
Set altitude(default altitude is
30
m)
Click start
Read the attentions
and confirm
24
25
DF805B
Operation Manual
DF805B
Operation Manual
When the GPS signal on the APP is null,follow me can not be used.
(2) How to use follow me
Warning:In order to ensure precise return location,please fly with good GPS signal,also at open field(no large
buildings in 50 meters,and the square circle is 10 meters flat ),RTH will work perfectly.
6. RTH
Click
to initiate RTH during flight if necessary,make sure to confirm the requirements, then click
“
OK
”
to start RTH,
aircraft will take the take-off point as the terminal to conduct RTH,All the joysticks will not be controlled during the course of the
return,During the descending process, the joystick can be manipulated to control the aircraft and change the landing position,if click
the
again during return course,aircraft will stop return course,Users will regain control of aircraft.
click the
again during return course,aircraft will stop return course,Users will regain control of aircraft.
Notice:Only when GPS has been positioned (rear arm green light is always on) to take off,no shelter Near the
take-off area,the accuracy of return position can be ensured. When aircraft under GPS mode,it will automatically
initiate the RTH as follows:
1 the aircraft lost contact with the RC
2 low battery capacity of aircraft
Initiate RTH mode,if the current flight height is less than 30meters,aircraft will automatically rise to
30meters to return,if the current flight height is higher than 30meters,aircraft will be returned directly, Inability
to manipulate the aircraft during RTH mode,please ensure that there is no obstacle in the return route in case of
accidents.
When the aircraft lands, please turn off the aircraft power after the propeller stops rotating(long press power button over 2seconds)
7 Way point flight
Click little map on the left corner at APP as shown,it will pop up map/Way point flight
When aircraft fly under GPS mode,click
(Way point flight) or
(Route planning flight),then read the attentions
carefully,click on the screen according to users needs in the current map, set course point,set the altitude of aircraft(default altitude
is 30m),after setting up,Click
to initiate Way point flight or Route planning flight,aircraft will fly automatically by course points.
During way point flight or route planning flight,click
to exit,after reaching the last flight point, the aircraft will hover in its
current position.
Caution:Please set course point or line in the circle (radius 100m),do not set the ourse point or line outside the red
circle,when exit the way point flight or route planning flight,aircraft will hover in its current position,users
can re-set course point and continue to fly,when users initiate RTH or one key landing during way point
flight or route planning flight,aircraft will exit the course,and perform RTH or one key landing immediately.
Warning:For safety and avoid property loss, please use way point flight or route planning flight carefully.when
using way point flight or route planning flight,Please choose an open, accessible area and stay away from
the crowd.carefully observe the current flight environment and set a safe flight altitude.
Summary of Contents for DF805B
Page 15: ......
