Online LED Store ©2012-2018 All Rights Reserved
Mounting Diagram # 2
Mounting Sur
face
Select a desired mounting location. Make sure there is at least 5” of clearance in order for
the light to fit properly over the mounting location.
Affix the L-shaped brackets to the light bar by using the included fasteners. Do not tighten
all the way.
Place the light bar with the L-shaped brackets over the desired mounting surface.
Mark the area where the mounting holes are to be drilled. Confirm that no vehicle parts
could be damaged by the drilling process.
Using a drill bit of appropriate size, drill a mounting hole for the Mounting Bolt. Thoroughly
de-burr all hole(s).
Secure the light unit onto the mounting surface using the included fasteners.
Adjust the light unit to the desired tilt angle prior to tightening the fasteners all the way.
Refer to Mounting Diagram # 2 for additional details.
1.
2.
3.
4.
5.
6.
7.
8.
L-shaped Brackets (12"+ models only)
RED – To 10-30 VDC Power Source
BLACK – To Chassis Ground
Input Voltage: 12 - 30 VDC
Model
CRLB06
CRLB12
CRLB24
CRLB42
CRLB78
CRLB96
Amperage @ 12 VDC
1
2
4
8
16
20
Output Wattage
18
36
72
126
234
288
Wiring
Specifications by Model
WARNING! All customer supplied wires that connect to the positive
terminal of the battery must be sized to supply at least 125% of the
maximum operating current and FUSED at the battery to carry that load. DO
NOT USE CIRCUIT BREAKERS WITH THIS PRODUCT!
