_ 17
User manual LAM3501 / LAM3502
09 - Care and maintenance
General information
Service life of the product will extend and the
possibility of problems will decrease if the product is
cleaned at regular intervals.
Risk of electric shock!
Switch off the electricity before cleaning appliance
to avoid possibility of an electric shock.
Hot surfaces may cause burns!
Allow the appliance to cool down before you clean it.
Clean the product thoroughly after each use.
This way it will be possible to remove cooking
residues more easily and will avoid burning
them on the next time the appliance is used.
No special cleaning agents are required for
cleaning the product. Use warm water with
washing liquid, a soft cloth or sponge to clean
the product and wipe with a dry cloth.
Always ensure any excess liquid is thoroughly
wiped off after cleaning and any spillage is
immediately wiped dry.
Do not use cleaning agents that contain
acid or chloride to clean the stainless steel
surfaces and the handle. Use a soft cloth with
a liquid detergent (not abrasive) to wipe those
parts clean, paying attention to sweep in a
horizontal direction.
The surface may be damaged by some
detergents or cleaning materials.
Do not
use aggressive detergents, cleaning powder/
cream or any sharp objects.
Do not
use steam cleaners for cleaning.
Cleaning the control panel
Clean the control panel and control knobs with a
damp cloth and wipe them dry.
Do not
remove the control knobs for control
panel cleaning.
Cleaning oven door and removing
the inner glass
Hot surfaces may cause burns!
when cleaning make sure that the appliance is
switched off and cooled down in order to avoid the
risk of an electrical shock or burns.
Don’t use any harsh abrasive cleaners or sharp
metal scrapers for cleaning the oven door or glass,
as they could scratch the surface and damage the
oven
The inner door glass can be removed to assist in
cleaning.
To remove the glass:
1.
open the door fully.
2.
The top cap can be pulled away from the
retaining clips.
Please Note:
When the upper cap is removed,
the glass will become loose, therfore care must be
taken to suport the glass at all times.
3.
The glass can now be lifted away from the door
assembley.
4.
To replace the glass follow this process in
reverse ensuring the printed surface of the
glass is facing downwards.
Care and maintenance
