23
Instructions and Installation
Before installation
The product must only be installed
by suitably qualified persons.
The product must be installed
in accordance with all local
regulations.
Prior to installation, visually
check the product for any
damage / defects. Do not
install if any issues are found.
Damaged products may cause
risks to your own safety.
• The appliance is intended for
installation in Howdens kitchen
cabinets.
• Surfaces, synthetic laminates
and adhesives used must be
heat resistant.
• Kitchen cabinets must be set
level and fixed.
• If there is a drawer beneath the
oven, a shelf must be installed
between oven and drawer.
• The following installation
drawings are representational
and may not match exactly
with your appliance.
12. Installation
** The oven may need to be
positioned lower in the cabinet
to fit with some hobs
Built under installation
Tower Installation
Note: Remove carcass rear panel
to assist with oven ventilation.
* A minimum of 150mm
2
ventilation
gap is required as illustrated
(45mm x 350mm cut-out)
positioned centrally.
350mm
*Any cut edges should be sealed
with a water proof varnish or PVA.
