Lamona LAM3207, User'S Installation Manual

Page: 14 / 24

1 2
Care and maintenance
General information
Service life of the product will extend and the
possibility of problems will decrease if the product is
cleaned at regular intervals.
Risk of electric shock!
Switch off the electricity before cleaning appliance
to avoid possibility of an electric shock.
Hot surfaces may cause burns!
Allow the appliance to cool down before you clean it.
Clean the product thoroughly after each use.
This way it will be possible to remove cooking
residues more easily and will avoid burning
them on the next time the appliance is used.
No special cleaning agents are required for
cleaning the product. Use warm water with
washing liquid, a soft cloth or sponge to clean
the product and wipe with a dry cloth.
Always ensure any excess liquid is thoroughly
wiped off after cleaning and any spillage is
immediately wiped dry.
Do not use cleaning agents that contain
acid or chloride to clean the stainless steel
surfaces and the handle. Use a soft cloth with
a liquid detergent (not abrasive) to wipe those
parts clean, paying attention to sweep in a
horizontal direction.
The surface may be damaged by some
detergents or cleaning materials.
Do not use aggressive detergents, cleaning powder/
cream or any sharp objects.
Do not use steam cleaners for cleaning.
Cleaning the control panel
Clean the control panel and control knobs with a
damp cloth and wipe them dry.
Do not remove the control knobs for control
panel cleaning.
Cleaning oven door glass
Don’t use any harsh abrasive cleaners or sharp
metal scrapers for cleaning the oven door. They
could scratch the surface and damage the glass.
Removal of the oven door glass
1. Open the door.
2. Lock the door by moving the clips at the hinge;
lift and move the cover backwards as
illustrated below:
3. Remove the screws as shown below:
4. Remove the top cover by pulling it up-wards (1)
leaving the inner glass free to remove (2).
Steps carried out during removing process should
be performed in reverse order to replace the glass.
Do not forget to close the clips at the hinges
when cleaning is complete.
5. Remove the glass by gently pulling it out of the
frame and clean.
Page _ 14
Do not place the door or inner glass panel on rough
or hard surfaces. Handle with care during removal,
cleaning and refitting