18_
LAMONA
Appliances
Installation
Before installation
The product should only be installed by suitably
persons.
The product must be installed in accordance
with all local regulations.
Prior to installation, visually check the product
for any damage/defects. Do not install if any issues
are found.
Damaged products may cause risks to your own
safety.
10 - Installation
The appliance is intended for installation in
Howdens kitchen cabinets.
•
Surfaces, synthetic laminates and adhesives
used must be heat resistant.
•
Kitchen cabinets must be set level and
•
If there is a drawer beneath the oven, a shelf
must be installed between oven and drawer.
•
The following installation drawings are
representational and may not match exactly
with your appliance.
560mm
560mm
460 mm
(min)
555mm
547mm
555mm
445mm
547mm
20 mm
20 mm
550 mm
min depth
550 mm
min depth
*
*
*
445mm
594mm
455mm
455mm
594mm
450 mm
(min)
Note: Remove carcase rear panel to assist with oven ventilation.
A minimum of 150cm² ventilation gap is required as Illustrated
(35mm x 500mm) cut out positioned centrally.
*
Tower Unit Installation
Built under installation
