Exclusive to Howdens Joinery.co
Page _ 17
User manual LAM2404
TROUBLESHOOTING GUIDE
Symptoms
Possible Cause
Solutions
Lamps fail to operate?
A replacement lamp is probably
(Remember that the lamps are not
covered by the guarantee.)
Disconnect the mains electricity supply before adjusting
or replacing the lamps.
The extractor lamps may become hot; therefore ensure
Power is cut.
Check if there is power. Check the fuses in the fuse box. If
necessary, replace or reset the fuses.
Motor is on but fan does
as usual?
ensure any venting is not obstructed?
The extractor works normaly
but smells linger?
unwanted smells.
Product does not operate?
The mains fuse maybe defective or
has tripped
Check fuses in the fuse box. If necessary, replace or
reset them.
Product is not connected properly.
Check all power connections.
If you cannot eliminate the problem after
following the instructions in this section,
consult your depot or the Authorized
Service Agent. Never try to repair a
nonfunctional product yourself.
Troubleshooting
TECHNICAL INFORMATION
General
Total power consumption
151W
Fuse
3 A
Voltage /Frequency
220-240 V ~ 50 Hz
Cable type / section
0.75mm², 2 core or equivalent
Lamps
E14 28W each
