Exclusive to Howdens Joinery.co
Page _ 13
User manual LAM2403
TROUBLESHOOTING GUIDE
Symptoms
Possible Cause
Solutions
Lamps fail to operate?
•
A replacement lamp is probably
necessary, but first check that the
lamp is correctly fitted into its holder.
(Remember that the lamps are not
covered by the guarantee.)
Disconnect the mains electricity supply before adjusting
or replacing the lamps.
The extractor lamps may become hot; therefore ensure
the bulb has cooled sufficiently before replacing.
•
Power is cut.
Check if there is power. Check the fuses in the fuse box. If
necessary, replace or reset the fuses.
Motor is on but fan does
not seem to be as efficient
as usual?
•
Clogged filters can reduce the
product’s efficiency. Check the grease
and charcoal filters (if fitted) also
ensure any venting is not obstructed?
Clean the grease filters with warm water and mild
detergent, and/or replace any charcoal filters
The extractor works normaly
but smells linger?
•
Clogged filters can reduce the
product’s efficiency and may cause
unwanted smells.
Clean the grease filters with warm water and mild
detergent, and/or replace any charcoal filters.
Product does not operate?
•
The mains fuse maybe defective or
has tripped
Check fuses in the fuse box. If necessary, replace or
reset them.
•
Product is not connected properly.
Check all power connections.
If you cannot eliminate the problem after following the instructions in this section, consult your
depot or the Authorized Service Agent. Never try to repair a nonfunctional product yourself.
Troubleshooting
Technical specification
TECHNICAL INFORMATION
General
Total power consumption
350W
Fuse
3 A
Voltage /Frequency
220-240 V ~ 50 Hz
Cable type / section
0.75mm², 2 core or equivalent
Lamps
E14 40W each
