Your clock is set, press and hold the SET button for 3 beeps to exit the
parameter menu.
Press and hold the ADJUST button for 2 beeps to manually connect
your Lamina Nixie Clock to your network.
The two neon light in the clock’s base are alternately flashing, and the
small light turns on under the middle tank.
If the clock can connect to your network the alternate flashing lights
stop, and the small light under the tank is continuously lit. If the con-
nection did not happened for any reason, the small tank light will
blink. You can repeat the manual sync to press again the ADJUST
button.
If there is no connection go over on the the previous steps from the
point where you reset parameter #29.
If your wifi network is not 2.4 GHz, the this function will not work.
If your location using daylight saving time (DST), the offset hours
need be set accordingly twice a year.
PARAMETER CHART
For more settings enter the clock parameter menu. To do this press
and keep pressed the SET button for 3 beeps. Pressing the SET button
once you step to the 1. parameter, press again for the 2. and so on.
The clock has 34 parameters to set/modify.
Every change is saved immediately. To exit the parameter menu do
the same as to enter, press and hold the SET button for 3 beeps.
You can exit the parameter settings anytime.
- 17 -
