16
●Document is not too thick?
Do not laminate too thick document. It may be a cause of failure.
Adjust velocity setting if setting is [0].
●Document is wrapped around the roller?
Press reverse button to pull documents if it remains in film entry. Do not pull it forcedly.
It may be a cause of failure. If there is no document in film entry, contact to our dealer or us.
Machine does not take or feed lamination material
In case of processing temperature is high, glue become so melt and boiling state
and has bubble or film become soften and have wave on the film.
If these situations occur, adjust paper and document not to be heated so much
by to increase the processing temperature or to lower the processing temperature.
* You can not reproduce it in the mentioned situation.
* You need to adjust temperature at 5°C increment.
* If this problem is not improved after adjustment, there may be any other causes.
Contact to our dealers or us.
In case processing temperature is high
In case of processing temperature is low, glue does not become transparent.
So the surface of document tends to be whitish or document and film tend to be peeled off.
If these situations occur, adjust the degree of melting glue given enough heat
by to increase the processing temperature or to lower the processing speed.
* You can not reproduce it in the mentioned situation.
* You need to adjust temperature at 5°C increment.
* If this problem is not improved after adjustment, there may be any other causes.
Contact to our dealers or us.
In case processing temperature is low
→ It is likely that processing temperature is low.
④ Film and documen are peeled off.
→ It is likely that processing temperature is high.
③ Finish is waving.
→ It is likely that processing temperature is low.
② Finish is whitish.
→ It is likely that processing temperature is high.
① Bubbles are generated.
●Confirmation of setting of temperature and speed
Check that adequate temperature and velocity for lamination is set referring from P12.
If they are not adequate setting, you may have trouble below.
In case that you can not laminate adequately