Lami Corporation Leon13DX, User Manual

Page: 18 / 20

Poor Quality Lamination
• Check the temperature and speed setting
See Page 13 to check whether the temperature and speed are set correctly per the laminate film
and mater ial used. I mp roper settings may result in poor quality of I am i nation, as shown below.
CD
Air bubbles trapped between the film and material
..... T
he laminate temperature may be too high .
..... T
he laminate temperature may be too low.
@
Extraordinary wave
..... T
he laminate temperature may be too high.
@
Separation between the film and material
..... T
he laminate temperature may be too low.
Laminate temperature too low
With too low laminate temperature, the adhesive may not melt wel I, which results in opaque-
looking finish and/or separation of the fi Im from the material. SI ightly increase the temperature or
decrease the laminate speed to give sufficient heat to the fi Im/material to ensure an appropriate
level of melting of the adhesive.

You cannot rework the laminated material.

Increase or decrease the temperature in steps of 40 o F.

If the trouble persists, there may be some other causes. Contact
your dealer.
Laminate temperature too high
With too high laminate temperature, the adhesive may boi I and bubble and the fi Im may be
softened and waved. SI ightly decrease the temperature or increase the laminate speed to
reduce heat to the fi Im/material.
M aterial will not laminate
•
Too thick material?
Inserting a material too thick may lead to the rol ler's incapability to rotate, and failure of the
equipment.
Do not insert materials thicker than the maximum allowable thickness.
If it has been set to [0], correct the setting.
•
Film or material jamming in the roll er s?
If the material is left in the entrance, remove it by using [REVERSE] button. Take care not to
pull the material too strongly. The equipment may otherwise be damaged. If the material is not
left in the entrance, contact your dealer.
17

You cannot rework the laminated material.

Increase or decrease the temperature in steps of 40 o F.

If the trouble persists, there may be some other causes. Contact
your dealer.
Leon13DX