lamber LP8/L-dy, Instruction Manual

Page: 13 / 48

13
To temporarly pause the cycle, simply open the
hood of the dishwasher.Closing it, the cycle will
start again at exactly the point were it was
interrupted.
It is possible at any time to stop the wash cycle by
simply pressing the button again cycle “B”
.
When you restart the cycle, this will restart from
the beginning.
(be carefull! During the cycle, at the opening of
the door is pressed also the fan for fume
extraction for a maximum time of 20 seconds –
only toP700-dy-CVP-S)
7
- At the end of the wash cycle , the
message “END WASH” will appear followed by a
short beep.
The LED turns off and the B button appear the
temperature data and the data number and
duration of the cycle.
Open the door of the machine.
Remove the basket and tilting it, shake it lightly to
bring down the remaing drops. Allow to dry the
objets by evaporation, then remove them from
the basket, taking care not to touch the inside
edge of the same. Then put them on hygienic
shelves.
To continue the wash load another basket and
close the door. The cycle will restart
automatically.
If you want to change the wash cycle, before
closing the door, you will need to select the new
cycle by pressing the time selection
“D” .
Temperature data display : to view temperature
data during the wash cycle, it is necessary to
press the push-botton . You will see the
temperature data for 3”.
If you want to fix the values of temperature for
the whole duration of the selected cycle, it is
necessary to press the button for 3”.
To re-display the data of the wash cycle, it is
necessary to press the switch .
Attention! At the next cycle the temperature data
will not be displayed automatically, but the data
will appear in the wash cycle.
ACHIEVEMENTS
Any deficiency in the washing process is
obvious when dirty residuals are visible. Any
halos might be caused by an insufficient rinsing:
in this case, check that the rinsing jets are clean
and that there is a sufficient pressure in the
water distribution network.
In case you find residuals, check that:
• the washing jets are clean
• there is some detergent
• the pump suction filter is clean
• objects in the rack are placed in a correct
position.
STAND BY-ECONOMY
(only available on a machine with automatic
start!):
The s tand-by function allows you to keep the
machine closed at rest, keeping active heating
functions
.
machine «ON»
Door
open
To start cycle
press button
keep
button
pressed
for 3 sec.
1
2
Stand-by : with open door and the machine is in
“ON”, press the cycle “B” push-button for 3
seconds, then closing the door, the machine will
not operate the wash cycle while maintaining
active heating functions.
The display shows the word “ECONOMY”. The
temperature of the heater stabilizes at 60°
reducing the consumption of energy.
Attention!: make sure, after you start the
stand-by function to close the doord to keep
the wash tank hot and not disperse heat!
To restart the cycle, put the door down and press
the push-button
“B” .
Automatic Stand-by : after 10 minuters of non-
use of the machine, with the door open , it
automatically activates the STAND BY-
ECONOMY, (the display shows the word
ECONOMY P*)
To restart the cycle, put the door down and press
the push-button
“B”.
If the machine is not used for 1 hour, the same
turns off completely (the machine “OFF”, even
turning off the heating elements).