LAMAX eTiger ATV40S, User Manual, Page: 19 / 150

12 13
EN
CS
CS
CZ
CZ
CZ
CZ
CZ
FUSE
–
Using pliers, take the included fuse and insert it into the protective case located on the left front of the
quad bike. A short spark may occur during insertion, which is normal.
STICKERS
–
If the stickers are protected by protective films, remove the film.
GEOMETRY
–
After assembly, it is sometimes necessary to
adjust the geometry of the front axles.
–
Adjust the toe-in/toe-out by turning the stee-
ring rod. Loosen both steering rod nuts (one
thread is right and the other is left). Loosen
both nuts (same side).
–
Align the handlebars and turn the hexagonal
rod to set the desired wheel direction (wheel
geometry). The wheels should be slightly
diverging.
–
After adjustment, carefully tighten all nuts.
NOTE
Estimate the geometry adjustments. For such small recreational vehicles, precise adjustment is not critical.
BRAKE ADJUSTMENT
–
Brake pressure may need to be adjusted. The brakes can be adjusted by using the extension bolts on the
Bowden cables, or by shortening or lengthening the cables directly on the brakes.
REAR SHOCK ABSORBER ADJUSTMENT
–
The stiffness of the rear shock springs can be
adjusted to the rider‘s weight. This can be
done by turning the nuts on the top of the
springs (see the image below). By turning the
nut clockwise, you reduce the stiffness of the
shock absorber. By turning the nut counter
-clockwise, you increase the stiffness of the
shock absorber.
CHECKS BEFORE RIDING
RELEASED PARTS
–
Before each ride, check that the steering and brake bolts are not loose. There must be no unusual noises,
rattling, loose or damaged components.
BRAKES
–
Check the correct operation of the brakes by pressing the lever. If you find that the quad does not brake,
you need to contact an authorised service centre.
FRAME, FORK AND HANDLEBAR
–
Check for cracked joints or broken parts. If you discover any of these defects on your quad bike, contact
an authorised service centre. Do not use the quad under any circumstances!!!