www.elakeside.com
4900 W. Electric Ave. West Milwaukee WI. 53219
414-902-6400
6
**** USER-MAINTENANCE AND STORAGE INSTRUCTIONS– SAVE THESE INSTRUCTIONS ****
Please follow cleaning instruction below when cleaning unit. No parts require lubrication.
Other than cleaning, all servicing is to be performed by a licensed electrician or an
authorized factory representative.
CLEANING OF STAINLESS STEEL
•
DO NOT use cleaners containing chlorides (chlorine), bromides, or iodides (consult
label or cleaner manufacturer).
•
ALWAYS rinse thoroughly with FRESH WATER after EVERY cleaning operation.
•
ALWAYS wipe dry to remove water (and possible hard water deposits) and to allow
protective oxide layer to reform.
•
DO NOT use steel wool, or other steel pads or brushes. They can leave iron metal
particles and cause rust formation.
•
ALWAYS rub in the direction of the steel grain for maximum effectiveness and to
avoid marring the surface.
•
Use the mildest cleaning procedure that will do the job effectively
•
FREQUENT CLEANING IS RECOMMENDED
OPERATION
CLEANING AGENT
PROCESS
Routine Cleaning
Use mild soap or detergent
diluted with warm water. If
more aggressive cleaning is
needed, add a small amount
of vinegar to the solution
being used.
Apply with sponge or clean
cloth. Rinse with clean warm
water. Wipe dry with a clean,
soft cloth.
Smears and Finger Prints
Use a commercial cleaner
such as 3M
®
Stainless Steel
Cleaner and Polish.
Use this cleaner as
instructed on the label.
Medium Dirt and
Discoloration
Use Soft Scrub
®
Cleanser
(WITHOUT CHLORINE
BLEACH)
Follow instructions on the
label. Apply and rub in the
direction of the steel grain.
Rinse thoroughly and wipe
dry with clean, soft cloth.
Grease and Oil
Any good commercial
detergent. (Consult label for
presence of chlorides,
bromides, or iodides).
Use this cleaner as
instructed on the label.
Refer to enclosed Point-of-Use Water Heater Owner’s Manual for water heater care and
use. If not enclosed, go to
www.insinkerator.com
for information on Model W152.