Electric Winch Kit p/n: 000007 rev A
2
doc: 400006 copyright© 2018 Lakeside Recreation, LLC
Assembly
If there is a PWC stored on the Shore Ramp PWC-50, remove it
and temporarily beach or anchor it safely out of the way.
Remove the Manual Winch from the PWC-50 by removing the
two 1” bolts that secure it to the winch strut. Retain the bolts,
nuts, and washers for mounting the Electric Winch Kit. The
manual winch can be retained as a backup if desired.
Mount the Electric Winch Kit to the Winch Strut using the two
1” bolts, washers, and locking nuts through the two central
holes under the center of the winch area. The motor and
control box must extend to the port side of the ramp (left side
when viewed from the water end of the ramp). The rope must
wrap under the drum as it extends out towards the water end
of the ramp.
Battery Requirements
The Electric Winch Kit is powered by a 12v deep-cycle “marine” battery supplied by the user. A typical group 24
marine/rv battery with 85 minutes “reserve capacity” should power the winch for 50 to 100 cycles between
charges (depending on the weight and slope). Retailers who sell automotive batteries typically also carry the
marine/rv models of batteries. (Wallmart, Sears, Home Depot, Menards, etc)
The Electric Winch Kit has 5/16” ring connectors suitable for the studs on marine/rv batteries or the bolted
connections on trolling motor batteries. The necessary wing nut or bolt may be supplied with the battery or
may need to be purchased separately.
Charging the battery will require a charger (also not included). When charging is necessary and power for a
charger is not nearby, the battery can be disconnected and charged at a location where power is available
A solar charging setup is recommended as a more convenient way to keep the battery fully charged.
A battery box is recommended to keep the battery and connections out of the elements.
Connect the Battery
WARNING – Batteries contain gases which are flammable and explosive. Wear eye protection during
installation and remove all metal jewelry. Do not lean over with your face close to the battery while making
connections.
Place the battery on the ground near the winch end of the ramp within reach of the power cables (6’ long).
Directly under the winch strut is a convenient location that is not a tripping hazard.
Connect the power cables to the battery. Use the wing nuts or bolts supplied with the battery. Connect the
Yellow wire to the positive (+) terminal of the battery. Connect the Blue wire to the negative (-) terminal of the
battery.
