Lake People DAC RS 06, User Manual

Page: 14 / 27

14
Polarity of the XLR terminals complies with AES 14-1992:
1 = ground, 2 = (+) in phase, 3 = (-) out of phase.
Source impedance of all analog outputs is significantly lower than
1 (one) Ohm !
NOTE:
When connecting unbalanced lines to the balanced outputs, pin 3 must
not be bridged but left unused (open). In this case the resulting output
level will be 6 dB less.
INPUT SELECTION
By pressing the
“INPUT SELECT“ button, the inputs BALanced >
COAXial > OPTO > USB can be selected.
If a valid signal is present at the corresponding input, the blue "lock"
LED will come up. Unused inputs or such with an invalid digital signal
present are indicated by the red
“MUTE / ERROR“ light.
THE RESAMPLING BUTTON
serves to switch on and off the resampling process.
The active resampling is shown by the yellow
“ON” LED.
Resampling means that all input jitter is removed and the input signals
are converted into a 96 kHz sample rate. This is the frequency at which
most contemporary converters perform best.