PO BOX 414
105 W. Simon St.
Laotto, IN 46763
Phone: 260-918-2758
Fax: 260-918-3540
E-mail [email protected]
Top
Silicone Pad
Battery Cover
Cover Screws
Top Screws
Lens
Base
3.2v
LiFePo4
3000mA
Battery
Use the provided wrench to separate your light:
The battery is not connected when shipped.
Connect Battery: Caution! When plugging battery connectors
together, align notches before joining both connectors.
Forcing or connecting backwards will damage the light.
3.2v LiFePo4
3000mA
Battery
MALE NOTCH
FEMALE NOTCH
Change brightness/power level at night by waving the
magnet over the solar panel
Holding the magnet for 5-seconds in the activation area
will change to the next LED color. You may then change
between brightness/power levels on that LED color.
Power Setting
* Run Times
100%
6-8 hrs
80%
7-9 hrs
65%
10-12 hrs
50%
13-14 hrs
35%
15-17hrs
20%
17-22 hrs
OFF
OFF
Holding for 5-seconds
Changes LED color
* Note:
Run times will vary significantly based on
factors such as; Sun Exposure, Season, Geographic
Location, Shading, Installed Location/Position, Battery
Condition, Brightness Setting, etc… The following run
times should only be used as a general reference and
are not guaranteed. Consider your local environment.
1
2
3
SOLAR PILING LITE
– 8”
MODEL: LL-SPL-8-X-WBA
www.lakelite.com
4
NEW MAGNET
SWITCH OPERATION
CHANGING BRIGHTNESS LEVELS
Wave the magnet over the solar
panel at night until you find the
activation area which changes
the brightness level.
Make a quick up & down motion
over this area to change between
brightness levels and OFF.
NOTE:
moving too slowly may
activate the magnet switch
multiple times going through
multiple levels at once. A quick
motion will help!
CHANGING LED COLORS
Hold the magnet over the
activation area for 5 seconds
until the LED color changes
