31
9.3 Cleaning of Strainer
2
Fig. 12:
Locations of coolant supply line and strainer
1 Strainer cover
2 Coolant supply line
1)
Disconnect the unit from mains.
2)
Remove the back panel.
Some amount of coolant will leak from the pump.
It is suggested you put sufficient amount of cloth in a circle underneath the strainer cap location.
3)
Remove the strainer cover using a metric AF 24 wrench.
4)
Take off the strainer and clean it. In case of damage the strainer must be replaced.
5)
Remount the strainer and screw on the cover.
6)
Should any coolant leak from the strainer the cap must be screwed on using a little more force.
7)
Remount the back panel.
8)
Start-up the unit for venting the cooling circuit (s. page 23).
9)
Check the coolant level and refill if required.
1
CAUTION
