CommandPro
®
23 Series
User Manual
20
142133 Rev B
7.3.2
Changing the Transmitter ID Code
Refer to
Figure 7
.
Remove the screws on the back of the transmitter and remove the back of the case.
1.
Attach the programming plug to the four-pin connector on the circuit board. Verify the ID CODE
2.
displays.
Enter the new ID Code and press the PRG key.
3.
Reassemble the transmitter in reverse order, making sure the battery wires do not get pinched
4.
between the case halves. Tighten the screws snugly.
Refer to the RAC16A User Manual for more detailed instructions.
7.3.3
Changing the Transmitter Keypad (Handheld)
Refer to
Figure 7
.
Remove the screws in the back of the transmitter and remove the back of the case.
1.
Remove the batteries from the holder.
2.
Remove the two (four) screws holding the printed circuit board assembly and remove the board
3.
from the case.
Remove the backing plate and rubber keypad from the case front.
4.
Install the new rubber keypad onto the backing plate, making sure the tabs are pulled through each
5.
slot.
Install the keypad and backing plate into the case front.
6.
Reassemble the transmitter in reverse order. Tighten screws snugly.
7.
