BL600-Sx Hardware Integration Guide
Single Mode BLE Module
Americas: +1-800-492-2320 Option 2
Europe: +44-1628-858-940
Hong Kong: +852-2923-0610
www.lairdtech.com/bluetooth
47
CONN-HIG-BL600
11
CE
R
EGULATORY
The BL600-SA / BL600-SC / BL600-ST have been tested for compliance with relevant standards for the EU
market. The BL600-SC and BL600-ST modules were tested with a 2.21 dBi antenna. The OEM can operate the
BL600-SC and BL600-ST modules with any other type of antenna but must ensure that the gain does not
exceed 2.21 dBi to maintain the Laird Technologies approval.
The OEM should consult with a qualified test house before entering their device into an EU member country to
make sure all regulatory requirements have been met for their complete device.
Reference the Declaration of Conformities listed below for a full list of the standards that the modules were
tested to. Test reports are available upon request.
11.1
Antenna Information
The antennas listed below were tested for use with the BL600. For CE mark countries, the OEM is free to use
any manufacturer’s antenna and type of antenna as long as the gain is less than or equal to the highest gain
approved for use (2.21dBi) Contact a Laird Technologies representative for more information regarding
adding antennas.
Item
Part Number
Mfg.
Type
Gain (dBi)
Model
1
AT5020-E3R0HBANT/LF
ACX
Ceramic
0
BL600-SA
2
EDA-8709-2G4C1-B27-CY MAG. Layers Dipole
2.0
BL600-SC
3
PCA-4606-2G4C1-A33-CY MAG. Layers Dipole
2.21
BL600-SC
4
EDA-8709-2G4R2-A40-CY MAG. Layers Dipole
2.0
BL600-ST
Note: The BL600 module internal BLE chipset IC pins are rated 4 kV (ESD HBM). ESD can find its way through
the external JTAG connector (if used on the customers design), if discharge is applied directly.
Customer should ensure adequate protection against ESD on their end product design (using the
BL600 module) to meet relevant ESD standard (for CE, this is EN301-489).
