Operator's Manual –
Dino Duel
©
LAI GAMES
Page 32
OPERATION
The mechanism dispenses cards from a cartridge using an electronically-controlled
DC motor to drive rollers via a gearbox and toothed belts. Cards are taken on demand
from the bottom of the stack by a clutch-driven roller assembly and offered forward
via the card guide to a feeder roller. The card continues its passage forward through
the mechanism aided by feeding and discharge rollers which present it to the delivery
point to await removal by the customer. Proximity sensors detect cards in the
discharge path and the empty state, inhibiting further demands while these conditions
persist. Accurate single dispensing is achieved by means of a reverse roller, adjusted
in relation to the thickness of the card to be dispensed.
REMOVING AND REPLACING THE CARTRIDGE
1.
Release the spring-loaded catch, located on the main chassis at the front right-
hand side of the dispenser and pull the cartridge back approximately 12mm to
clear the locating lugs before lifting clear of the mechanism.
2.
Replacing is a reversal of removal but take care to ensure that the guides on
the side of the cartridge are correctly located over the mechanism side plates
and the lugs are situated inside the recesses of the main chassis before sliding
it into the fitted position.
LOADING CARDS
1.
Prepare the stack of cards that will be loaded into the card dispenser.
2.
Remove the card cartridge from the main chassis and open the cartridge.
3.
Take the thick weight plate off from the cartridge.
4.
Gently put the cards into the cartridge from the front of the cartridge, a stack at
a time until the cartridge is full.
5.
Put the thick weight plate back into the cartridge on the top of the cards’ stack.
6.
Close the cartridge and put it back into the main chassis.
* NOTE! *
When loading the cards into the stack holder, always put the magnetic side face
down. Do not put the cards with the magnetic side face up.
