28
PXl16 Sheartec:II Planer \ Maintenance
Conveying Rollers
WARNING
·
TURN PLANER OFF AND DISCONNECT POWER BEFORE PERFORMING ANY MAINTENANCE OR ADJUSTMENTS!
MAINTENANCE: Keep rollers clean to help prevent slippage of material. Be careful not to contact
cutterhead knives as they are very sharp!
ADJUSTMENTS: The planer comes set-up from the factory and typically will not need adjustment. If it is
determined adjustment is needed, follow these steps for setting the infeed roller, chip breaker, pressure bar
and outfeed roller; 1. Make a hardwood block to the specifications in drawings (Figures 14 & 15). Use this
wood gauge along with 0.02” feeler gauge to set the planer up as shown in Fig. 16.
FIGURES 14 & 15: SET-UP-BLOCK
FIGURE 16: CUTTERHEAD
Summary of Contents for Sheartec:II PXl16
Page 1: ...PXl16 Sheartec II Planer Owner s Manual MPLANPX16 0130 3 10 2021...
Page 24: ...24 PXl16 Sheartec II Planer Setup Assembling FIGURES 10 12 DRO ADJUSTMENT...
Page 38: ...38 PXl16 Sheartec II Planer Replacement Parts Diagram Table Lift...
Page 39: ...39 PXl16 Sheartec II Planer Replacement Parts Diagram Stand Motor...