POWER SUPPLY
Warning:
For your own safty and protection of property, consult an electrician if you are
unsure about wiring practices or electrical codes in your area.
Caution:
If the plug does not fit the available receptacle, or the machine must be
reconnected for use on a different type of circuit, or use an extension cord with this
machine, the reconnection must be made by a qualified electrician and comply with all
local codes and ordinances.
Nominal Voltage-----------220V/240V
Cycle--------------------------50/60Hz
Phase-------------------------Single-Phase
Power Supply Circuit----- 15Amps (T-50), 20Amps (T-60)
ASSEMBLY & SETUP
Location of the lathe
A level concrete floor is the best location for the lathe. The lathe should be located in a dry
area. Keep electrical box and motor away from direct sun shine. Plenty of space around
the lathe is good for operations and maintenances.
Unpacking
Report any damage to your shipping agent or dealer immediately as soon as check for
shipping damage.
Check the shipping crate with the following parts list to make sure all parts are intact. If
there is any missing parts please report to your dealer. Read this manual thoroughly for
assembly, maintenance, operation and safety instructions.
Contents of the Shipping Crate(Fig.1)
A, Lathe bed with Headstock,
Tailstock, Tool Rest Base (Banjo),
Tool Rest
B, Leg Assemblies x 2
C, Knockout rod x 1
D, Face plate wrench x 1
E: Spindle lock rod x 1
F: Live center pin x 1
G: Live center x 1
H: Spur center x 1
I: 12mm alan wrench x 1
J, 3mm alan wrench
K,12mm bolt x 6
L, 12mm spring washer x 6
M, 12mm flat washer x 2
N, Tool storage bracket x 1
O, Foot x 4
P, Operation Manual
Fig. 1
