laguna PX20, Owner'S Manual

Page: 9 / 43

9
Wear respirator. Fine dust that is too small to be caught in the filter may be introduced
into the ambient air during operation. Always wear a NIOSH-approved respirator during
operation and for a short time after to reduce your risk of permanent respiratory
damage.
Disconnecting power supply. Turn the switch off, disconnect from the power supply,
and allow machine to come to a complete stop before leaving the machine unattended or
doing any service, cleaning, maintenance, or adjustments.
Suspended dust particles and ignition sources. Do not operate in areas were
explosion risks are high. Areas of high risk include, but are not limited to, areas near
pilot lights, open flames, or other ignition sources.
Fire suppression. Only operate in locations that contain a fire suppression system or
have a fire extinguisher nearby.
Static electricity. Plastic dust lines generate high amounts of static electricity as dust
chips pass through them. Although rare, sparks caused by static electricity can cause
explosions or fire. To reduce this risk, make sure all dust lines are thoroughly grounded
by using a grounding wire.
Regular cleaning. Regularly check the machine for excessive dust and debris and
clean. Make sure to regularly clean the surrounding area where the machine is
operated
—
excessive dust buildup on overhead lights, heaters, electrical panels, or other
heat sources will increase the risk of fire.
SAVE THESE INSTRUCTIONS.
Refer to them often and use them to instruct others.
Please read and save these instructions. Read carefully before attempting to assemble,
install, operate or maintain the product described. Protect yourself and others by
observing all safety information. Failure to comply with instructions could result in
personal injury and/or property damage! Retain instructions for future reference.
DO NOT EXPOSE THE MACHINE TO RAIN OR OPERATE THE MACHINE IN DAMP
LOCATIONS.
MOTOR SPECIFICATIONS
The typical main motor is 5 HP and is wired for 400-415 Volt, Three -Phase, 5 0 HZ, AC
current. Confirm your motor electrical configuration before connecting power! Before
connecting the machine to the power source, make sure the starter and switches are in
the "OFF" position. Power Cord and “plug” are NOT included. These must be installed by
a qualified technician/electrician to meet all applicable codes.
Confirm electrical configuration (Voltage & Phase) of this machine before connecting to
power source!