14
NOTE:
Make sure the dust collection system has sufficient
capacity and CFM for this planer. Always turn ON the
dust collector before planning.
Figure 5: Dust Chute & Hood Clips
Opening Hood
1. Release the 2 Clips (Fig. 5) on each side of the hood.
2. Remove the two lower screws holding the dust chute in place (Fig. 5)
3. Raise hood until automatic latch secures hood in open position
4. To close, press IN automatic latch while lowering hood
Cutting Limiter
The Limiter (Fig. 6) acts as a stop to prevent the cutterhead from contacting the
table and to prevent stock from sliding past the edge of the cutterhead.
Feed Speed Selector
The feed speed selector offers two feed speeds, 16 FPM & 28 FPM. Move lever
(push/pull
front to back
) until it locks in place. The middle setting is neutral.
Change feed speeds ONLY when the machine is running!
H
I
Clips, hood (2)
Summary of Contents for PX20
