laguna JX12 Sheartec:II, Owner'S Manual

Page: 9 / 56

9 JX|12 & JX|16 Sheartec:II Jointers \ Electrical Safety
MJ16X100P-0130
VOLTAGE 220V
PHASE 3PH
HERTZ 60Hz
FULL LOAD AMPERAGE 20AMP
Below are RECOMMENDATIONS to be used for this machine based on the above
information. Variables that may affect this are:
·
Actual voltage supplied to the machine
·
Electrical code that must be met in your local province.
An electrician will verify that all the demands are met to properly wire the machine. If you have
absolutely any doubt when wiring this machine - please consult with a qualified electrician.
PLUG/RECEPTACLE Not Included
WIRING (Gauge) See Jacket Printing
CIRCUIT BREAKER 25Amp
If this information is different than what is stated on the Motor Specification Plate - omit this information. It
is possible that the documentation is outdated to a machine change - such as a different motor. Always
check the motor plate prior to any wiring. If any doubts, please consult a certified electrician.
Know when to use a time delay fuse! AKA Slow blow fuse. Generally, if the motor uses a start capacitor, a
time delay fuse is required. This type of fuse (circuit breaker) will not trip with the initial amperage needed
to start the machine, which is typically double that of the running amperage. Most woodworking machines
use this type of fuse.