19
Support table
Fit the support table to the shaft as detailed earlier.
Elongate the holes so that the fence support table is approximately level with
the top of the band saw table and snug tight the lock nuts.
You do not have to fully tighten at this stage, as the shaft will have to be fine-
tuned once the fence is fitted. Slide the fence onto the clamp plate and snug
tight the fence with the clamp levers.
Fence 1/16 inch material
With the fence over the front stud, lay a piece of material approx 1/16-inch
thick on the table under the fence. The thickness is not important. It is advisable
when setting up the fence that it contact the table at the end furthest away from
the drift master and is not in contact with the table anywhere else. This will
greatly reduce the friction when moving the fence.
Summary of Contents for DriftMaster
Page 6: ...7 Parts of the drift master 4 9 12 13 10 8 7 6 5 4 3 2 1 11...
Page 28: ......
