laguna 37x2, Owner'S Manual

Page: 7 / 48

7
U
NPACKING
Y
OUR
S
UPER
M
AX
The sander has been shipped mostly assembled
from the factory in a cardboard shroud on a pallet.
If any damage has occurred as a result of shipment,
notify the transportation company as soon as pos-
sible and ask them to make an immediate inspec-
tion. Ask for a damage or loss report. Also notify
your dealer of any loss or damage during ship-
ment. See Warranty Statement.
Important : To avoid problems and potential
damage to the machine, please read through the
unpacking instructions below before proceeding to
set up the machine in your shop.
1. Unbolt the machine legs from the shipping
pallet. Install the casters on legs (Fig. 2) with a
washer and nut. Tighten with a 3/4” wrench.
The casters and mounting hardware are
packaged with the machine.
2. Loosen the hex nut and set screws on the table
support castings (Fig. 3). The set screws on the
table support castings have been tightened at the
factory to eliminate free-play between the table
support casting and the column tube during ship-
ment. There are two table support castings on the
S
UPER
M
AX
, one each for the right and left column
tubes. Important: These set screws are tightened
for shipping and must be loosened and readjusted
before operating either the height adjustment
mechanism or the conveyor drive.
To properly adjust for operation, loosen each set
screw by first loosening its hex nut with an open-
end wrench and then the set screw with an Allen
wrench. Then retighten each set screw with your
fingers so it only lightly touches the column tube.
Hold each set screw in position with an Allen
wrench and retighten the hex nut. Failure to fol-
low these procedures may result in misalignment
of the drum(s) and/or the conveyor table.
Caution : On the S
UPER
M
AX
models do not
loosen the set screws on the upper drum support
castings.
3. If necessary, adjust the tension of the V-belt
between the primary motor and driven pulleys. To
do this, loosen the two screws in lower belt guard
and loosen the pinch bolt located at the back of
the motor support casting. Slide the motor sup-
port casting down the column tube until the V-
belt is taut. Tighten the two screws in lower belt
guard. Retighten the motor support pinch bolt.
Fig. 2. Caster and mounting hardware. Fig. 3. Table support casting and set screws.
T
ABLE
S
UPPORT
C
ASTING
H
EX
N
UT
& S
ET
S
CREWS