Arrow up Arrow down
Stop
26
Setting the Spoil Board on the Vacuum Table for Production
Moving the Router Head to the Spoil Board Corner Position
1.
With the router head in the home position, drop the router bit to just above the
spoil board top face as described earlier [Z axis].
2.
Use the distance command as described earlier [press mode, toggle through
to distance] to set the X and Y position to 40.38mm.
3.
Press X+.
4.
Once the router head has stopped moving press Y+.
5.
The point of the router bit is now located over the point where the corner of the
spoil board should be.
6.
You may need to move the router bit lower so that it is closer to the top surface
of the spoil board by pressing the Z- button.
7.
Press the top right hand button XY-0 / 4 this will set the origin and the machine
now has a new datum point which will be the X=0 / Y=0 in your design
program.
8.
Move the spoil board so that the corner of the spoil board is directly under the
point of the router bit and adjust the spoil board position so that it is parallel with
the edges of the vacuum table. Vacuum can now be applied to the spoil board.
Re-Setting the Origin Point
1.
Bring the router head to the origin point by pressing origin button.
2.
Lower the router bit by pressing Z= so that it is just above the spoil board.
Note
the position of the tip of the router bit point and you will probably find the
origin point will have to be adjusted.
3.
Jog the point over so that it lines up with the edge of the spoil board in the X axis.
4.
Jog the point over so that it lines up with the edge of the spoil board in the Y axis.
5.
Reset the origin point by pressing the top right hand button XY-0 / 4. This will
set the origin and the machine now has a new datum point.
Spindle Speed Control
Only three buttons are operator accessible:
ARROW UP, ARROW DOWN, and STOP
KEY.
ARROW UP key is used to raise the spindle
speed.
ARROW DOWN Key is used to lower the
spindle speed.
The stop key is available to stop the spindle
during a program activation.
Display reads in hertz, 200hz = 12,000, 300hz
= 18,000, 400hz = 24,000
Summary of Contents for SMARTSHOP I 4x8
Page 2: ......
