10
Where to locate your machine.
Before you remove your machine from the pallet, select the area where you will use
your machine. There are no hard-and-fast rules for its location, but below are a few
guidelines.
1.
There should be an area at the front and back of the machine suitable for the
length of wood that you will be machining.
2.
Adequate lighting. The better the lighting, the more accurate and safely you will
be able to work.
3.
Solid floor. You should select a solid, flat floor, preferably concrete or something
similar.
4.
Close to power source and dust collection.
Unpacking your machine.
To unpack your machine, you will need tin snips, knife and a wrench.
1.
Using the tin snips, cut the banding that is securing the machine to the pallet (if
fitted).
WARNING: EXTREME CAUTION MUST BE USED BECAUSE THE
BANDING WILL SPRING AND COULD CAUSE INJURY.
2
. Lift the box off and discard.
3.
Using the knife, cut the plastic wrap from the top. The accessories that were
ordered could be attached to the side of the machine, and extreme caution must be
taken so that the parts do not fall and cause injury or damage. Remove them and
set aside.
4.
Some of the parts supplied with the machine may be shipped inside the machine.
To access these parts, remove the machine side panels.
5
. Remove the base mounting bolts that secure the machine to the pallet. The
mounting bolts are accessed from
underside of the pallet [If fitted].
6.
The machine can be lifted using
a forklift truck or hoist.
To lift the machine off the pallet
using a sling, pull the lifting rods out
from the machine’s main body. Fit
the sling around the sling rods and
lift the machine off the pallet with a
hoist. The hoist must have a lifting
capacity of no less than 2000 lbs.
Remove the pallet and lower the
machine to the floor.
Note.
The machine is heavy, and if
you have any doubt about the
described procedure, seek
professional assistance. Do not attempt any procedure that you feel is unsafe or that
you do not have the physical capability of achieving.
Lifting rods
Summary of Contents for MPLAN1510-0120
