Laguna Tools MPLAN1510-0120, Manual

Page: 15 / 72

15
production. As the machine is used, some functions may move, and it is good
practice to know the process for adjusting the machine prior to production.
Test Run
Now that the assembly is complete it is time to conduct a test run.
During the test run you will check the following points.
1. Motor starts and runs smoothly.
2. That the stop buttons function correctly.
Before you run the machine check the following.
1.
All the tools have been removed from the machine.
2. All the guards are in place.
3. You are wearing the appropriate safety equipment.
4 . You have read and understood the
instruction manual.
Note. If any of the below functions fail to
operate correctly, the fault must be
corrected prior to continuing to the next
test. Any investigation to find or correct a
fault must be conducted with the power
disconnected.
1. Start the machine by pressing the green
start button.
The machine should run smoothly with little
or no vibration.
2. Press the red stop button. The machine
should slow down and stop.
Power feed.
Stop and start buttons
Power feed handle