Laguna Tools MJOIN 8012-0130, Manual

Page: 20 / 33

20
2. Adjust the stop screw so that it touches the back of the fence, and lock in position
with the lock nut.
3. Unlock the fence and move. Move the fence back to the 45 degree stop and lock
in position. Check that the fence is at 45 degrees. If the fence is not at 45 degrees,
readjust.
Adjusting the 90 degree stop
1.
Adjust the fence to 90
degrees using a set square, and
lock in position.
2. Move the flip stop to the
position shown.
3. Adjust the stop screw so that
it touches the flip stop, and lock
in position with the lock nut.
4. Unlock the fence and move.
Move the fence back to the 90
degree stop and lock in position.
Check that the fence is at 90
degrees. If the fence is not at 90
degrees, readjust.
Maintenance
As with any machine, to ensure optimal performance you must conduct regular
maintenance.
Daily checks.
1.
Clean the machine and lubricate unpainted surfaces with a Teflon lubricant. Wipe
off any excess and buff with a dry polishing cloth. This will reduce the likely hood of
rust forming and reduce the friction on the tables as the wood is machined.
2. Check cutter teeth for chips and dullness.
3. Generally inspect the machine for damage and loose or warn parts.
Weekly checks.
1.
Clean the cutter head.
2. Check cutter teeth for chips and dullness.
3. Generally inspect the machine for damage and loose or warn parts.
4. Check the dust extraction for blockages and any large bits that could cause
blockages.
Monthly checks.
1.
Check the motor drive belts for wear, splits and cuts.
Set square