17
The stops come pre-set, but should adjustment be required, see the guide lines
below.
Adjusting the 45 degree stop
1.
Adjust the fence to 45 degrees using a set
square, and lock in position.
2.
Adjust the stop screw so that it touches the
back of the fence and lock in position with the lock
nut.
3.
Unlock the fence and move. Move the fence
back to the 45 degree stop and lock in position.
Check that the fence is at 45 degrees. If the fence
is not at 45 degrees, readjust.
Adjusting the 90 degree stop
1.
Adjust the fence to 90 degrees using a set
square, and lock in position.
2.
Adjust the stop screw so that it touches the back
of the fence, and lock in position with the lock nut.
3.
Unlock the fence and move. Move the fence
back to the 90 degree stop and lock in position.
Check that the fence is at 90 degrees. If the fence
is not at 90 degrees, readjust.
Maintenance
As with any machine, to ensure optimal
performance you must conduct regular
maintenance.
Bearings
Most of the bearings are sealed and require no
lubrication.
The following should be lubricated every 80 hours
of use.
Cutter head
The cutter head has two bearings that required
greasing. There are white stickers pointing to their
general location. There are two grease fittings, one
at each end of the cutter head. The grease fitting on the front side of the jointer is
located in a small hole cut into the top of the front base housing. The grease fitting
on the back side of the machine is located on the top of the jointer base just under
the bottom edge of the fence.
45 degree stop screw and
lock nut
90 degree stop screw and
lock nut
Grease point