18
Manual Tool Release
The tool holder can be released from the spindle manually by pressing the
green manual release button near the
Electro-Spindle.
Note.
When the green manual release
button is pressed, the clamping method is
released and the tool will fall out. Place
your hand so that the tool holder (not the
cutter) is supported.
To manually insert a tool holder, hold the
tool holder in the spindle taper while
holding the green manual release button. Once the green manual release
button is released, the tool holder will be pulled up into the spindle hole and
clamped in position. Please note that a small amount of air escapes from the
spindle nose. This is used to blow any dust out of the spindle taper and is
normal.
Note:
Keep the tool holders clean, lubricated with Teflon.
Note:
The spindle taper is susceptible to rust and must be kept clean and
lubricated with a Teflon lubricant.
Summary of Contents for MCNC SS2 4X8 6 HP LIQUID COOLED
Page 2: ......
Page 26: ...SMART SHOP II REV 1 10 31 2012...
