Laguna Tools L A175017, Manual

Page: 21 / 28

21
Maintenance. General.
Keep your machine clean. At the end of each day, clean the machine. Wood contains
moisture, and if sawdust or wood chips are not removed they will cause rust. In general, we
recommend that you only use a Teflon based lubricant on the lathe. Regular oil attracts dust
and dirt. Teflon lubricant tends to dry and has fewer tendencies to accumulate dirt and saw
dust. Periodically check that all nuts and bolts are tight.
Drive belt.
The drive belt should last for many years [depending on the usage] but need to be inspected
regularly for cracks, cuts and general wear. If damage is found, replace the belt.
Bearings.
All bearings are sealed for life and do not require any maintenance. If a bearing
becomes faulty, replace it.
Rust.
The lathe is made from steel and cast iron. All none painted surfaces will rust if not
protected. It is recommended that they are protected by applying wax or a Teflon based
lubricant
Troubleshooting.
The lathe will not start
.
1.
Check that the rotation switch is not in the “0” position.
2. Check that the electrical power cord is plugged into the power outlet.
3. Check that the electrical supply is on [reset the breaker].
4. With the power disconnected from the machine, check the wiring to the plug is correct.
Check that the rubber insulation is stripped enough and is not causing a bad connection.
Check that all the screws are tight.
The machine will not stop.
This is a very rare occurrence as the machine is designed to fail-safe. If it should occur
and you cannot fix the fault, seek professional assistance. The machine must be
disconnected from the power and never run until the fault has been rectified.
1. Stop switch faulty. Replace the stop switch.
2. Forward, off, reverse switch faulty. Replace the switch.
Motor tries to start but will not turn.
1. With the power disconnected from the machine. Try to turn the spindle by hand. If the
spindle will not turn, check the reason for the jamming.
2. Capacitor faulty. Replace the capacitor.
3. Motor faulty. Replace the motor.