F1 Table Saw
31
Wiring
VOLTAGE. Before connecting this tool to a power supply (receptacle, outlet, etc.) make sure that
the voltage supplied is the same that is specified on the nameplate of the tool. IF IN DOUBT, DO NOT PLUG
IN THE MACHINE. Using this tool with a voltage different than that stated on the nameplate can damage the
electrical components of this machine and any such damage will not be covered by a warranty.
CIRCUIT BREAKER. Also make sure that the power supply is equipped with the appropriate
breaker and plug according to your local electrical code. To do this, first check the motor plate to get the
FLA amperage of the machine, if worn out or not present then refer to the specifications sheet. If there is
any doubt in regards to choosing the appropriate circuit breaker, please consult an electrician or an
electrical supply source.
ELECTRICAL SHOCK. It is extremely dangerous to work on live wires and/or electrical systems
that are connected to a power source. ALWAYS disconnect the power from the machine prior to performing
any maintenance or adjustments.
MOTOR WIRING: The information in this manual was current at the time of printing but may be
different than the diagram on your machine. ALWAYS use the supplied wiring diagram with the machine or
motor (under the electrical covering) if present.
Summary of Contents for Fusion F1
